User`s guide

168
The value in this text box defines the maximum value for the routing metric. The default
value is 16.
Route directed IP broadcasts
When checked, this checkbox causes the router to route directed broadcasts. The default
state for this parameter is “Off”. A directed broadcast is an IP packet with a destination
address that is a valid broadcast address for a subnet but does not originate from that
subnet. Directed IP broadcasts are used to send a broadcast from one interface to the
subnet of another.
Wait s seconds before using an alternative route
The value in this text box specifies the latency to apply before passing traffic on an
alternative route in the current route becomes unavailable.
If an interface is configured for “dial on demand” and fails to connect,
Mark a static route as “Out Of Service” for s seconds
The value in this text box specifies the default time that a route should be marked as out of
service if the interface it uses fails to establish a connection.
When an “Always On” route becomes “In Service”, wait s seconds before using it
The value in this text box specifies the delay that the router should apply to a route before
passing traffic on it once it has come into service.
Related CLI Commands
Entity
Instance
Parameter
Values
Equivalent Web Parameter
ip 0 cidr on,off Enable CIDR routing
ip 0 admin_connected
0 -
2147483647
Connected Interfaces
ip 0 admin_static
0 -
2147483647
Static Routes
ip 0 admin_ebgp
0 -
2147483647
eBGP Routes
ip 0 admin_ospf
0 -
2147483647
OSPF Routes
ip 0 admin_rip
0 -
2147483647
RIP Routes
ip 0 admin_ibgp
0 -
2147483647
iBGP Routes
ip 0 inf_metric
0 -
2147483647
Maximum static route metric
ip 0 route_dbcast 0 - 255 Route directed IP broadcasts
ip 0 route_dly
0 -
2147483647
Wait s seconds before using
an alternative route
ip 0 route_dwn
0 -
2147483647
If an interface is configured
for “dial on demand” and fails
to connect, Mark a static
route as “Out Of Service” for
s seconds