User`s guide

165
Entity
Instance
Parameter
Values
Equivalent Web Parameter
dyndns 0 debug OFF,ON Enable debug
IP Routing / Forwarding - An introduction to TransPort routing
Configuration – Network > IP Routing/Forwarding
The Configuration – Network > IP Routing/Forwarding menu has the following sub-
menu options:
• IP Routing
• Static Routes
• RIP
• OSPF
• BGP
• IP Port Forwarding / Static NAT Mappings
• Multicast Routes
The TransPort’s routing table can be viewed by navigating to Management - Network
Status > IP Routing Table.
The TransPort’s routing table can also be displayed using the CLI command:
route print
Types of route
TransPort routers support three main types of route:
Dynamic Routes
Static Routes
Default Routes
Dynamic Routes
Dynamic routes are created automatically when an interface is configured or connected.
For example configuring an Ethernet 0 interface with an IP address of 192.168.1.1 and
mask of 255.255.255.0 will cause a dynamic route to be created automatically.
Thus any packet with destination IP address in the range 192.168.1.0 to 192.168.1.255 will
automatically be routed through to the Ethernet 0 interface.
Static Routes
Static routes can be added by configuring a route in Configuration - Network > IP
Routing/Forwarding > Static Routes > Routes 0 – 9 > Route n (where n is an
instance number).
The minimum configuration required to add a static route is:
IP Address
Mask
Interface
Interface number