User`s guide

164
Entity
Instance
Parameter
Values
Equivalent Web Parameter
dyndns 0 ifent Blank,ETH,PPP
When default route/interface
x,y becomes active, send
DDNS update
dyndns 0 ifadd 0 -2147483647
When default route/interface
x,y becomes active, send
DDNS update
dyndns 0 wildcard
0,1,2
0 = Disable
wildcards
1 = Enable
wildcards
2 = No change
to service
settings
Use Wildcards
dyndns 0 provider_hostname
Up to 40
characters
[Decription: User specified
service provider]
Advanced
Configuration – Network > Dynamic DNS> Advanced
The parameters in this section do not normally need changing from their defaults.
Update interval d days
The value in this text box specifies the number of days between dynamic DNS updates.
Supply the IP address in the update
When checked (the default), this checkbox cause the router to supply the IP address as part
of the dynamic DNS update. When unchecked, the IP address is not supplied and the
DYNDNS server attempts to determine the correct IP address by other means (IP source
address in update packet). This mode would normally only be used if the router is behind a
NAT router.
Note:
It may be helpful to visit the www.dyndns.com website before attempting configuration of
dynamic DNS.
Only send update when this router is the VRRP master
When checked, this checkbox causes the router NOT to send DDNS updates unless at least
one Ethernet interface is a VRRP master.
Enable debug
When checked, this checkbox enables debug tracing of the dynamic DNS transactions.
Related CLI Commands
Entity
Instance
Parameter
Values
Equivalent Web Parameter
dyndns 0 updateint 0 -255 Update interval d days
dyndns 0 noip OFF,ON
Supply the IP address in the
update
dyndns 0 ifvrrpmaster OFF,ON
Only send update when this
router is the VRRP master