User`s guide

149
Entity
Instance
Parameter
Values
Equivalent Web Parameter
ppp n l_bacp OFF, ON Request BACP
ppp n l_callb OFF, ON Request callback
ppp n r_callb
0 – 2
0 = Off
1 = Desired
2 = Required
Allow remote end to request
callback
ppp n l_md5
0 - 2
0 = Disabled
1 = Enabled
2 = Preferred
Allow this unit to authenticate
using CHAP-MD5
ppp n r_md5
0,1
0 = Off
1 = On
Allow remote unit to
authenticate using CHAP-MD5
ppp n l_ms1
0,1
0 = Disabled
1 = Enabled
2 = Preferred
Allow this unit to authenticate
using MS-CHAP
ppp n r_ms1
0,1
0 = On
1 = Off
Allow remote unit to
authenticate using MS-CHAP
ppp n l_ms2
0 - 2
0 = Disabled
1 = Enabled
2 = Preferred
Allow this unit to authenticate
using MS-CHAPv2
ppp n r_ms2
0,1
0 = Off
1 = On
Allow remote unit to
authenticate using MS-CHAPv2
QoS
Configuration – Network > Interfaces > Advanced> PPPn> QoS
The parameters on this page control the Quality of Service management facility. Each PPP
instance has an associated QoS instance, where PPP 0 maps to QoS 0, PPP 1 maps to QoS 1
and so on. These QoS instances include ten QoS queues into which packets may be placed
when using QoS. Each of these queues must be assigned a queue profile from the twelve
available.
Enable QoS on this interface
This checkbox, when checked, reveals the following QoS configuration parameters:-
Link speed n Kbps
The value in this text entry box should be set to the maximum data rate that this PPP link is
capable of sustaining. This is used when calculating whether or not the data rate from a
queue may exceed its minimum Kbps setting as determined by the profile assigned to it and
send at a higher rate (up to the maximum Kbps setting).
Queue n