User`s guide

136
Entity
Instance
Parameter
Values
Equivalent Web Parameter
ppp n cingnb up to 25 digits
Only allow numbers ending with
n
ppp n msn up to 9 digits with ISDN MSN ending with n
ppp n sub up to 17 digits
with ISDN sub-address ending
with n
ppp n maxup 0 2147483648
Close the PPP connection after s
seconds
ppp n maxuptime 0 2147483647
if it has been up for m minutes
in a day
ppp n timeout
Default 300s (5
minutes)
if it has been idle for h, m, s
ppp n timeout2 0 2147483648
Alternative idle timer for static
routes s seconds
ppp n rxtimeout 0 2147483648
if the link has not received any
packets for s seconds
ppp n maxneg 0 2147483648
if the negotiation is not
complete in s seconds
ppp n do_nat
0,1
0 = Off
1 = On
Enable NAT on this interface
ppp n natip
Valid IP address
a.b.c.d
NAT Source IP address a.b.c.d
ppp n ipsec
0,1
0 = Off
1 = On
Enable IPsec on this interface
ppp n ipsecent
Default
PPP
Ethernet
Use interface x,y for the source
address of IPsec packets
ppp n ipsecadd
Valid interface
number
Use interface x,y for the source
address of IPsec packets
ppp n firewall OFF, ON
Enable the firewall on this
interface
Mobile
Configuration – Network > Interfaces > Advanced>PPP n> Mobile
Mobile telephone modules fitted into the router use PPP to connect to the network and send
and receive traffic. This section describes parameters relevant to setting up a mobile
telephone module.
Use SIM Any, SIM1, SIM2
These radio buttons are used to select which of the SIM cards fitted should be used by the
module.