User`s guide

135
is NOT checked, as incorrect firewall rules will prevent a connection from passing network
traffic. If the connection works when the firewall is turned off but fails when turned on, a
good place to start checking parameters would be in the firewall settings page,
Configuration – Security > Firewall.
Related CLI Commands
Entity
Instance
Parameter
Values
Equivalent Web Parameter
ppp n name Free text field Description
ppp n phonenum up to 25 digits Dial out using numbers
ppp n ph2 “ “
ppp n ph3 “ “
ppp n ph4 “ “
ppp n prefix 0 – 9999999999 Prefix n to the dial out number
ppp n username Valid username Username
ppp n password Valid password Password
ppp n epassword
The encrypted
password
None – this parameter is not
configurable
ppp n IPaddr
Default 0.0.0.0 set
automatically
Allow the remote device to
assign a local IP address to this
router
ppp n IPaddr
Valid IP address
a.b.c.d
Try to negotiate a.b.c.d as the
local IP address for this router
ppp n IPaddr
Valid IP address
Default 1.2.3.4
Use a.b.c.d as the local IP
address for this router
ppp n mask
Valid IP address
Default
255.255.255.255
use mask a.b.c.d for this
interface
ppp n DNSserver Valid IP address Primary DNS server
ppp n secDNS Valid IP address Secondary DNS server
ppp n DNSport
Valid IP address
Default 53
DNS Port
ppp n IPmin
Valid IP address
Default
10.10.10.10
Assign remote IP addresses
from a.b.c.d to a.b.c.d
ppp n IPrange
0 – 255
Default 5
Assign remote IP addresses
from a.b.c.d to a.b.c.d Note that
these are not directly
equivalent. This address is
obtained by adding the range
value to the minimum.
ppp n transDNS Valid IP address Primary DNS server
ppp n sectransDNS Valid IP address Secondary DNS server