User`s guide

121
Escape char c
The parameter in this text entry box is the ASCII character used as the escape character
which is by default “+”. Entering this escape character three times followed by a pause of at
least the “Escape delay” parameter below and then an “AT” command will cause the router
to switch back to command mode from online mode. This is equivalent to the “S2” register
setting.
Escape delay s milliseconds
The parameter in this text entry box defines the delay required between entering the escape
sequence (default “+++”) and the “AT” command in order for the router to drop back into
command mode. This is equivalent to the “S12” register setting.
Related CLI Commands
Entity
Instance
Parameter
Values
Equivalent Web Parameter
transip n port
Valid port number
0 – 65535
Listen on port
transip n host
Valid IP address
a.b.c.d or
hostname
Connect to IPaddress a.b.c.d or
Hostname
transip n remport
Valid port number
0 – 65535
Port
transip n keepact 0 – 255
Send TCP Keep-Alives every s
seconds
transip n staycon ON,OFF Enable Stay Connected mode
transip n cmd_echo_off ON,OFF Disable command echo
transip n escchar
Valid ASCII
character
Escape char c
transip n esctime 0 – 255 Escape delay s milliseconds
RealPort
Configuration> Network> Serial> Realport
The Configuration> Network> Serial> Realport page: