User`s guide

115
This parameter determines the character used in the escape sequence. The default is the
“+” symbol (ASCII value 43, 0x2b). Changing this value has the same effect as changing
the “S2” register.
Escape Delay s x 20 milliseconds
This parameter defines the required minimum length of the pause (in multiples of 20ms) in
the escape sequence. The default is 50 x 20ms which means that the escape sequence
becomes “+++”, a pause of 1 second and then “AT” in order to drop back to AT command
mode. Enter the desired delay into the text box if a delay of some other value is required.
Forwarding Timeout s x 10 milliseconds
This parameter defines the length of time that the router will wait for more data after
receiving at least one octet of data through the serial port and transmitting it onwards. This
timer is reset each time more data is received. The router will forward data onwards when
either the forwarding timer expires or the input buffer becomes full. This parameter applies
to ADAPT, TCPDIAL, TCPPERM and PANS.
Break Transmit Escape Character c
This parameter determines the character used in the escape sequence. The “-” symbol
(ASCII value 45, 0x2d) is a recommended value. Changing this value has the same effect as
changing the “S3” register. To use the break sequence, type “-” 3 times, with a 1 second
pause either side of the 3 “-” characters.
When the Async port detects the following sequence....
<guard time 1 sec>---<guard time 1 sec>
instead of outputting the three minus characters (they are removed from the output
stream) a BREAK condition is placed on the Async transmitter for 1 second.
Related CLI Commands
Entity
Instance
Parameter
Values
Equivalent Web Parameter
S0=n n/a n/a
Where n =
0 - 255
Answer V.120 call after n
rings
&Cn n/a n/a
Where n =
0 = On
1 = Auto
2 = Off
3 = Pulse low
DCD
&Dn n/a n/a
Where n =
0 = None
1 = Drop line
2 = Drop line & call
3 = Drop call on
transition
4 = Drop line & call
on transition
DTR
S45=n n/a n/a
Where n =
0 - 255
DTR de-bounce
S2=n n/a n/a
Where n =
ASCII value
Escape Character
S12=n n/a n/a
Where n =
0 - 255
Escape delay
S15=n n/a n/a
Where n =
Forwarding Timeout