User`s guide

92
Entity
Instance
Parameter
Values
Equivalent Web Parameter
ppp n secDNS
Valid IP address
a.b.c.d
Use the following DNS servers if
not negotiated
Secondary DNS server a.b.c.d
ppp n IPmin
Valid IP address
a.b.c.d
Assign remote IP addresses
from a.b.c.d to a.b.c.d
ppp n IPrange 0 - 255
Assign remote IP addresses
from a.b.c.d to a.b.c.d
ppp n transDNS
Valid IP address
a.b.c.d
Primary DNS server a.b.c.d
ppp n sectransDNS
Valid IP address
a.b.c.d
Secondary DNS server a.b.c.d
ppp n ans OFF,ON
Allow this PPP interface to
answer incoming calls
ppp n cingnb up to 25 digits
Only allow calling numbers
ending with n
ppp n do_nat
0,1,2
0 = Disabled
1 = IP address
2 = IP address
and port
Enable NAT on this interface
IP address/IP address and Port
ppp n nat_ip
Valid IP address
a.b.c.d
NAT Source IP address a.b.c.d
ppp n ipsec
0 = Disabled
1 = Enabled
2 = Enabled and
Keep SAs
Enable IPsec on this interface/
Keep Security Associations
when this ISDN interface is
disconnected
ppp n firewall OFF,ON
Enable the firewall on this
interface
Configuration Network > Interfaces > ISDN > Advanced
Metric
The value in this text box specifies the route metric that should be applied to this interface.
(see Configuration – Network > Interfaces > Advanced > PPP n for more detail.)
Enable “Always On” mode of this interface
When checked, this checkbox causes the following two options to appear:
On/On and return to service immediately
These two radio buttons select whether the “always-on” functionality should simply be
enabled or whether the additional facility to return the interface to the “In Service” state
should be applied.