User`s guide

61
Note:
If the firewall is enabled on an interface and with the absence of any firewall rules, the
default action is to block ALL traffic.
Related CLI Commands
Entity
Instance
Parameter
Values
Equivalent Web Parameter
ppp 1 do_nat 1
Enable NAT on this interface
IP Address
ppp 1 do_nat 2
Enable NAT on this interface
IP Address and Port
ppp 1 ipsec 1 Enable IPsec on this interface
ppp 1 ipsec 2
Keep Security Associations (SAs)
when this Mobile interface is
disconnected
ppp 1 ipsecent blank,ETH,PPP
Use interface X, Y for the source
IP address of IPsec packets
x = Interface type
ppp 1 ipsecadd 0 - 255
Use interface X, Y for the source
IP address of IPsec packets
y = interface number
ppp 1 firewall on/off
Enable the firewall on this
interface
Configuration – Network > Interfaces > Mobile > SIM Selection
This section allows you to launch the Dual SIM wizard for failing over from 1 SIM to another.
Click here to launch the Dual SIM wizard
Click the hyperlink to launch the Dual SIM wizard.
CDMA Provisioning
If the router was not supplied pre-provisioned, obtain the following details from the Service
Provider:
a 15 digit IMSI (International Mobile Subscriber Identity)
an NAI (Network Access Identifier)
an NAI password
Once these details have been obtained, it is possible to provision the CDMA module by
inserting those details into the ‘Automatic Provisioning’ section of this web page and clicking
on the Start button.
See
Quick Note 25 – “CDMA Provisioning on a Digi TransPort Router” for
example configuration.
Automatic Provisioning
If required, enter the MSL/PTN/MSID parameters before clicking Start