User`s guide

52
When the Wi-Fi interface is configured to be an Access Point, in order to forward packets to
and from the Wi-Fi interface it must be bridged with an Ethernet interface using a Bridge
instance.
Interface
The interfaces that are currently members of the selected Bridge instance. Note that
multiple Wi-Fi interfaces can be members of the same Bridge instance.
Link this Wi-Fi client interface with Ethernet n
When the Wi-Fi interface is configured to be a client, it must be bridged to a particular
Ethernet interface.
This Wi-Fi rogue scanner will use Ethernet n
When the Wi-Fi interface is configured to be a rogue scanner, it will use the selected
Ethernet interface.
Hide SSID
When enabled, the SSID will not be included in the beacon messages transmitted by the Wi-
Fi interface when in Access Point mode. This means that Wi-Fi clients will not be able to
auto-detect the Access Point.
Isolation
When enabled, connected Wi-Fi clients will not be able to communicate with other Wi-Fi
clients or Ethernet hosts connected to this AP.
Related CLI Commands
Entity
Instance
Parameter
Values
Equivalent Web Parameter
wifinode 0 enabled on, off Enable this Wi-Fi interface
wifinode 0 descr String Description
wifinode 0 ssid
String up to 32
characters
SSID
wifinode 0 mode ap, client, rogue Mode
wifinode o bridge_inst 0 - 3
This Wi-Fi interface is a member
of Bridge instance n and
therefore bridged to the following
interfaces
eth n bridge_inst 0 – 3 Interface
eth n wificli on, off
Link this Wi-Fi client interface
with Ethernet n
eth n wificli_add Integer
Link this Wi-Fi client interface
with Ethernet n
wifinode 0 broadcastssid on, off Hide SSID
wifinode 0 isolation on, off Enable station isolation
Configuration - Network > Interfaces > Wi-Fi > Wi-Fi n - Wi-Fi Security
This section is used to configure the security settings for the Wi-Fi interface.