User`s guide

43
Related CLI Commands
Entity
Instance
Parameter
Values
Equivalent Web Parameter
eth n macfilt on, off
Enable MAC filtering on
Ethernet interfaces
macfilt n mac
MAC address with no
separators.
Partial MAC address
are allowed.
MAC Address
Configuration - Interfaces > Ethernet > ETH n > MAC Bridging
The Ethernet MAC bridge function will create an Ethernet bridge between two physically
separate Ethernet networks. It is possible to allow bridging over DSL, W-Wan, ISDN and
PSTN connections but note that the only restriction on the traffic sent across the link is done
via MAC address filtering and that all Ethernet traffic will be bridged, no firewall restrictions
are applied to this traffic.
Once the bridge has been configured, the MAC addresses to bridge need to be configured in
the MAC bridge table.
Enable
Enable MAC bridging on the Ethernet interface.
Forward to IP address
The IP address of the remote router to which the Ethernet packets will be bridged to.