User`s guide
404
Conversely, you may wish to only capture traffic to and from particular IP hosts. To do
this, use a tilde (~) symbol before the list of IP addresses. For example, to only capture
packets to and from IP host 192.168.47.1, enter “~192.168.47.1” for this parameter.
Related CLI Commands
Entity
Instance
Parameter
Values
Equivalent Web Parameter
ana 0 anon on, off Enable Analyser
ana 0 maxdata 16 - 2000 Maximum packet capture size
ana 0 logsize 3 -180 Log Size
ana 0 l1on on, off Protocol Layers / Layer 1
ana 0 l2on on, off Protocol Layers / Layer 2
ana 0 l3on on, off Protocol Layers / Layer 3
ana 0 xoton on, off Protocol Layers / XOT
ana 0 ikeon on, off Enable IKE debug
ana 0 qmion on, off Enable QMI trace
ana 0 snaipon on, off Enable SNAIP trace
ana 0 lapdon
0 – 7
See below
ISDN Sources
ana 0 lapbon
0 – 7
See below
LAPB Links
ana 0 asyon
Bitmap
See below
Serial Interfaces
ana 0 syon
Bitmap
See below
Raw SYNC Sources
ana 0 discardson on, off IP Options / Trace discarded packets
ana 0 loopon on, off IP Options / Trace loopback packets
ana 0 ipfilt
Comma
separated list
IP Packet Filters / TCP/UDP Ports
ana 0 ipprotfilt
Comma
separated list
IP Packet Filters / IP Protocols
ana 0 ipaddfilt
Comma
separated list
IP Packet Filters / IP Addresses
ana 0 discportfilt
Comma
separated list
Discarded IP Packet Filters / TCP/UDP
Ports
ana 0 discprotofilt
Comma
separated list
Discarded IP Packet Filters / IP
Protocols
ana 0 discipaddfilt
Comma
separated list
Discarded IP Packet Filters / IP
Addresses