User`s guide

329

Configuration – System > General

This section describes the configuration of router functionality that applies to the router in

general rather than specific features.

Configuration – System > General > Autorun Commands

The router may be configured to run a number of commands once it has booted. These

commands are associated with specific asynchronous serial interfaces. Configuration of this

facility is via a table on this web page. As an example, it may be required that a Script Basic

script, sample.bas needs to be run at boot up. Auto commands are normally associated

with an ASY port, but running a script for example is not ASY port specific.

This parameter is the command interface to be associated with the command. In the above

example, this would be set to the number “0”.

This parameter is the CLI command to run on start-up. In the above example, this field

would be set to the string “bas sample.bas”.

Related CLI Commands

Entity

Instance

Parameter

Values

Equivalent Web Parameter

cmd n autocmd

Valid CLI

command

Autorun Commands