User`s guide

318
Configuration – Alarms > Event Logcodes > Configuring Events
This page controls the configuration of the event that is displayed in bold font at the top of
the page, just below the blue title bar.
Do not log this event
When checked, this checkbox disables logging of the event.
Note:
This parameter is not saved in the logcodes.txt file but in the config.dan file. This means
that after changing this parameter, the changes must be saved by clicking the save changes
link when prompted (this appears after clicking the “Apply” button). Clicking the Save All
Event Code Changes will not have the desired effect.
Log Priority
This parameter sets the priority of the event to determine whether the event will trigger
emails, SMS messages or SNMP traps. 0 = disabled, 1 = highest priority, 9 = lowest priority
Alarm Priority
If the above “Inherit alarm priority from event” checkbox is not checked, this parameter
selects the priority of the reason. Valid values are 0 to 9.
Alarm Priority is dependent on the event being logged by Entity
Selecting this checkbox makes the priority conditional on which system entity triggered the
event (e.g. ethernet) and enables the following two configuration options:
Entity
This drop-down selection box contains a list of the system entities.
All
Selecting this radio button causes all of the system entities
Instance
Selecting this radio button enable a text entry box that allows the user to enter the
instance of the selected entity.
Priority only applies to
This configuration section comprises a set of checkboxes, each checkbox controlling whether
the priority is applied to that interface instance. So for example, to apply the priority to PPP
interface 1, click on the checkbox labelled PPP 1.
Store a snapshot of the Traffic Analyser trace on the log drive
Selecting this checkbox causes a snapshot of the analyser trace to be stored on the USB
flash drive
If this event creates an Email alarm
Attach a snapshot of the Traffic Analyser trace
Checking this checkbox will cause a snapshot of the analyser trace to be attached to the
email.
After this event
Leave the Analyser trace
This option will leave the analyser trace unchanged.