User`s guide

316
These radio buttons selects which method of establishing a route to the server should be
used.
Routing table
When this radio button is selected, the routing table is used to determine the interface that
will be used to transmit the syslog message.
Interface x,y
If the routing table is not to be used, an interface type (PPP or Ethernet) may be selected
from the drop-down selection box and the interface instance number may be typed into the
adjoining text entry box. The route is then determined by that interface.
Priority
The checkboxes listed in this section select the event priorities that should cause the event
to be logged.
Facility
The checkboxes listed in this section select which of the router facilities should be logged.
Related CLI Commands
Entity
Instance
Parameter
Values
Equivalent Web Parameter
syslog n server IP address Syslog server IP address
syslog n port IP port number Port
syslog n mode UDP, TCP, RFC3195 Mode
syslog n tcp_to
Timeout in seconds,
e.g. 86400
TCP timeout s seconds
syslog n source_ent PPP, ETH
Interface x,y
x = Interface type
syslog n source_add 0 - 4
Interface x,y
y = interface number
syslog n priority
Hyphen separated
0 – 7
Comma separated
0,3,5
or ‘all’
Priority checkboxes
syslog n facility
Hyphen separated
0 – 23
Comma separated
4,3,5,10,15,22
or ‘all’
Facility checkboxes