User`s guide

284
Entity Instance Parameter Values
Equivalent Web
Parameter
pad n amacro text
Use X.25 Call Macro
macroname to an ATD
command
pad n cingnua text (valid NUA) Use NUA
pad n lcn 1 - 4095 LCN
pad n lcnup 1 = up, 0 = down LCN Direction
pad n nuaimode
0 = NUI and NUA, 1 = NUA
only, 2 = NUI only
NUI/NUA selection
pad n dorest 1 = enabled, 0 = disabled
Enable X.25 Restart
Packets
pad n restdel 0 - 60000 (ms) Restart delay
pad n IPaddr text Remote IP address
pad n buipaddr text
Remote IP Address when
using the backup interface
pad n ip_port 0 - 65535 IP Stream port
pad n iphdr
0=Off, 1=On, 2=8583 Ascii
4 byte
IP length header
pad n prompt text PAD prompt
pad n padmode
0 = Normal, 1 = Prompt
Always On
PAD mode
pad n profile 1-4, 50, 51,90,91 Use PAD Profile
pad n strip_tspaces 1 = enabled, 0 = disabled Strip Trailing Spaces
pad n llmode 1 = enabled, 0 = disabled Enable Leased Line Mode
pad n enqcon 1 = enabled, 0 = disabled Send ENQ on Connect
pad n stxmode 1 = enabled, 0 = disabled
Enable STX / ETX Filtering
pad n delconmsg 0 - 10
Delay connect message n
x 10 millisecondss
pad n data_del 0 - 2147483647
Delay data transfer after
connection by n x 10
milliseconds
pad n inacttim 0 - 1000
Terminate the PAD call
after x seconds if there
has been no data
transmission
pad n nocalltim 0 - 60000
Disconnect the layer 2 call
if there is no layer 3 call in
progress for x seconds
pad n trig_str text
Create an event when the
following data is on the