User`s guide

258
Entity
Instance
Parameter
Values
Equivalent Web Parameter
RAW_NOHDR
snaip x ans 1 = enabled, 0 = disabled Allow this unit to answer calls
snaip x msn text
Only accept calls with MSN ending
with
snaip x sub text
Only accept calls with sub-address
ending with
snaip x autocontact
1 = enabled, 0 = disabled
Assume station exists (Do not
send TEST frames)
snaip x dcd_toggle 1 = enabled, 0 = disabled
Toggle DCD output each time the
DLSw protocol enters the
DISCONNECTED state
snaip x l1oos 1 = enabled, 0 = disabled
Sync port should not send or
receive data when WAN link is
down
snaip x master 1 = enabled, 0 = disabled
Router to be Master on an
unbalanced link
snaip x pollresp 0 - 2147483647
Polling Response Time
snaip x stations text Polling Stations Addresses
snaip x saps text SAPs
snaip x dsaps text DSAPs(blank=default)
snaip x send_xid_null 1 = enabled, 0 = disabled
Send Null XID (XID with no Data)
snaip x xid_data text Send XID with Data
snaip x turntxtim 0 - 2147483647 Tx Turn Around Time
snaip x dtemode 1 = DTE, 0 = DCD Mode
snaip x n400 0 - 255 N400 counter
snaip x tnoact 1000 - 60000 RR Timer
snaip x t1time 1 - 60000 T1 timer
snaip x t200 1 - 60000 T200 timer
snaip x window 1 - 7 Window Size
snaip x tinact 0 - 3000
Disconnect link if there has been
no activity for x seconds
snaip x vmac Text (valid MAC address) Virtual MAC Address
snaip x peervmac Text (valid MAC address) Virtual MAC Address of Peer
snaip x IPaddr Text (valid IP address) IP address of the Peer DLSw unit
snaip x r_IPport 0 - 65535 Listen on Port
snaip x w_IPport 0 - 65535
Use Port x if this unit starts the
DLSw protocol