User`s guide

25
Correct entry of the username and password will display the main operations page similar to
that shown below.
Clicking on the Click to load Applet graphics! button will display a representation of the
front panel of your unit that will be updated every few seconds to show the actual status of
the LED indicators. The model number of your unit will be shown at the top of the screen.
The unit’s serial number and ID are shown below the front panel representation.
Down the left side of the page you will see, the main menu with subsections which further
expand when clicking on them.
Configuring and Testing W-WAN Models
Refer to the Configuration - Network > Interfaces > Mobile section of this guide to
configure your router for the correct APN and PIN code (if any). You can now power up your
unit and test connection to the wireless network. If you have correctly configured
everything, the W-WAN SIM indicator on the front panel should illuminate green to show
that a W-WAN enabled SIM card is present. The unit will now attempt to log on to the
specified mobile network and if it is able to do so, the W-WAN NET indicator will illuminate
steady. Data passing to and from the network will be reflected by the status of the DAT
indicator, which will flash green. If you are unable to connect to the network, go to the
Management - Network Status > Interfaces > Mobile web page and press the Refresh
button. The page should appear similar to the following: