User`s guide

181
Use Interface IPsec source IP
When checked, this checkbox will cause OSPF functions to use the source IP address of the
interface specified in Configuration – Network > Interfaces > Advanced > PPP n :
Use interface x,y for the source IP address of IPsec packets on the interface being
used. When unchecked, OSPF will use the source IP address of the interface being used for
its source address.
Related CLI Commands
Entity
Instance
Parameter
Values
Equivalent Web Parameter
ospf 0 Enable on,off Enable OSPF
ospf 0 conffile OSPF Configuration Filename
ospf 0 new_cfg_rest on,off
Restart OSPF after a
configuration file is saved
ospf 0 fatal_rest on,off
Restart OSPF if a fatal error
occurs
ospf 0 debug
0 – 3
0 = Off
1 = Low
2 = Med
3 = High
OSPF Tracing
ospf 0 ignore_mtu on,off Ignore MTU indications
ospf 0 useipsecent on,off Use Interface IPsec source IP