User`s guide

175
Entity
Instance
Parameter
Values
Equivalent Web Parameter
def_route n actooslim 0 – 2147483647
Mark this route as “Out Of
Service” if the interface fails
to connect after n
consecutive attempts
def_route n chkoos_int 0 – 2147483647
If the interface fails to
connect, try again in s
seconds
def_route n
chkoos_deac
t
0 – 2147483647
Deactivate the interface after
it successfully connects
def_route n dial_int
0 – 255
Default 10
Do not allow this interface to
be activated by this route for
s seconds after the last
activation attempt
def_route n q1 on,off
Only queue one packet whilst
waiting for the interface to
connect
def_route n deact_ent Blank,PPP
When this route becomes
available, deactivate the
following interfaces x,y
def_route n deact_add 0 – 2147483647
When this route becomes
available, deactivate the
following interfaces x,y
def_route n deact_ent2 Blank,PPP
When this route becomes
available, deactivate the
following interfaces x,y
def_route n deact_add2 0 – 2147483647
When this route becomes
available, deactivate the
following interfaces x,y
def_route n unoos_secs 0 – 2147483647
Keep this route in service for
s seconds after OOS state is
cleared
def_route n rgroup 0 - 255
Assign this route to recovery
group n
Configuration – Network > IP Routing / Forwarding > RIP
The web pages and command line commands described in this section control the
configuration of the routing Information Protocol (RIP) functionality of the router.
Configuration – Network > IP Routing / Forwarding > RIP > Global RIP
Settings
Enable RIP
When checked, this checkbox enables the RIP functionality.