User`s guide

174
Wait for s seconds after power up before allowing this route to activate the
interface
As per equivalent parameter in Routes n.
If the interface is configured for “dial on demand”
Mark this route as “Out Of Service” if the interface fails to connect after n
consecutive attempts
As per equivalent parameter in Routes n.
If the interface fails to connect, try again in s seconds
As per equivalent parameter in Routes n.
Deactivate the interface after it successfully connects
As per equivalent parameter in Routes n.
Do not allow this interface to be activated by this route for s seconds after the last
activation attempt
As per equivalent parameter in Routes n.
Only queue one packet whilst waiting for the interface to connect
As per equivalent parameter in Routes n.
When this route becomes available, deactivate the following interfaces x,y x,y
As per equivalent parameter in Routes n.
When this route becomes unavailable, remove the “Out Of Service” state on x,y
As per equivalent parameter in Routes n.
Keep this route in service for s seconds after OOS state is cleared
As per equivalent parameter in Routes n.
Assign this route to recovery group n
As per equivalent parameter in Routes n.
Related CLI Commands
Entity
Instance
Parameter
Values
Equivalent Web Parameter
def_route n metric 0 – 2147483647
Use metric n when the
interface is not active
def_route n srcip
Valid IP address
a.b.c.d
IP Address a.b.c.d
def_route n srcmask
Valid netmask
a.b.c.d
Mask a.b.c.d
def_route n inrip on,off
Include this route in RIP
advertisements
def_route n doinact2 on,off
Make PPP n interface use the
alternative idle timeout when
this route becomes available
def_route n inact2add 0 – 2147483647
Make PPP n interface use the
alternative idle timeout when
this route becomes available
def_route n pwr_dly 0 - 255
Wait for s seconds after
power up before allowing this
route to activate the interface