User`s guide

173
Configuration – Network > IP Routing / Forwarding > Static Routes >
Default Route n
The following two web pages and associated command line commands are used to set up
default IP routes that will be used to route non-local IP addresses not specified in a static
route. The parameters are identical to those on the static route pages with the exception
that there are no IP address or Mask parameters.
Description
The text in this text box is used to assign a convenient and memorable description for the
route.
Default route via:
Gateway a.b.c.d
As per equivalent parameter in Routes n.
Interface x,y
As per equivalent parameter in Routes n.
Metric n
As per equivalent parameter in Routes n.
Related CLI Commands
Entity
Instance
Parameter
Values
Equivalent Web Parameter
def_route n descr Up to 20 characters Description
def_route n gateway
Valid IP address
a.b.c.d
Gateway a.b.c.d
def_route n ll_ent Blank,PPP,ETH,TUN Interface x,y
def_route n ll_add 0 – 2147483647 Interface x,y
def_route n upmetric 1 - 16 Metric
Configuration – Network > IP Routing / Forwarding > Static Routes >
Default Route n > Advanced
Use metric n when the interface is not active
As per equivalent parameter in Routes n.
Use this route only if the source IP address of the packet matches
As per equivalent parameter in Routes n.
IP address a.b.c.d
As per equivalent parameter in Routes n.
Mask a.b.c.d
As per equivalent parameter in Routes n.
Include this route in RIP advertisements
As per equivalent parameter in Routes n.
Make PPP x interface use the alternative idle timeout when this route becomes
available
As per equivalent parameters in Routes n.