Installation guide

TransPort
®
WR41 Installation Guide
Page 9
[Rear of Unit]
[Front of Unit]
2.3 Under Unit Features
2.3.1 Reset button
The reset button allows the user to return the unit to its factory default settings. It is recessed [to avoid
accidental reset], and can be accessed via a small 2.5mm hole located on the underside of the unit.
2.3.2 Reset instructions
Step 1) Turn the unit on and wait 15 seconds for the unit to complete its initialization process.
Step 2) Press and hold the reset button gently for 5 seconds. After this time, the unit will automatically re-boot
and display a pattern of alternating LEDs ashing followed by the normal boot sequence.
Note: Do not remove power from the unit during this operation as corruption of the ash memory may occur.