User`s manual

Step 1. Set Up the Main Board
Before installing the SYNC/570i-56 in an ISA system, you must set the I/O address.
NOTE
If you are installing the SYNC/570i-56 in a Micro Channel system, skip this step. Continue with the daughterboard configuration as
described in Step 2.
Set the multi-segment switch on the main board. The setting of the switch selects the starting address of the block of I/O
locations which the
SYNC/ 570i-56 uses.
The SYNC/570i-56 is shipped with a setting of 300H.
Diagrams of commonly used I/O address switch settings begin on the following page.
NOTE
All I/O addresses mentioned in this manual are in hexadecimal format.