User`s manual

CHAPTER SIX
Configuring the Micro Channel SYNC/570 and
SYNC/570i
Configure the SYNC/570 and SYNW57Oi through your computers Micro
Channel Programmable Options Select @OS) system, using data from the
Digi Adapter Definition File (ADI on the diagnostic diskette. This system
uses hardware registers, selected and loaded through software, to assign
system resources to an expansion board. Each type of expansion board has
its own unique code number, assigned in conjunction with the computer
manufacturer, which identifies it to the system. <If you cannot determine
the proper setup information, check with an operating system vendor or
Digi Customer Support.)
zE!L
NOTE
Refer to JQW computer system documentation for informution on the
Programmable Option Select.
-
1.
Install the board as described in Section 4.
2. Determine which ADF file on the Digi Diagnostics Diskette you need
for configuration. Refer to the note below for an explanation of the
files. If necessary, copy and rename the file you need.
,q
NOTE
The diagnostics diskette actually contatns tbme ALIFfiks:
@6163.AD4
@6163.4X, and @6163.AD2. Thefiles @GlG3ADF and @6163ALIl are
tahticaL clots ADFCple is the one that b copied to your reference dtskette.)
i%e ADF and AD1 flks contain the most commonly used con_f&urations.
The @6163ALI2jIk contains everypcxslbk option for conflguratlon.
Isyou wish to use the AD2Jile, you must copy thefile to the wfmnce
diskette as @6163_ALIF. Since the reference dtikette will copy only the ALIF
fire, copy tbeji’le to another diskette and rename tt ALIF.
15