User`s manual

MiniCore RCM5700/RCM6700 User’s Manual rabbit.com 89
E.3.2 Add Additional Boards
The Prototyping Board and the two accessory boards included with the Deluxe Development Kit
may be installed on the Interface Board as shown in Figure E-6.
Figure E-6. Install Additional Boards
1. Insert the header strip into header socket J2 on the Interface Board or the board already
installed above the Interface Board.
2. Line up the board being installed above the pins extending from the header socket and the
stand-offs/connectors.
3. Press down to install the board.
4. Insert additional plastic standoffs/connectors as shown to hold the board firmly in place and to
hold another board if desired.
When additional boards are installed, the board-to-board spacing is 0.7" (17.8 mm). Multiple
boards should be installed in this sequence from bottom to top.
• Interface Board with MiniCore installed.
• Prototyping Board.
• Serial Communication accessory board.
• Digital I/O accessory board.