User`s manual

MiniCore RCM5700/RCM6700 User’s Manual rabbit.com 66

B.6 Interface Board Jumper Configurations

Figure B-7 shows the header locations used to configure the various Interface Board options via

jumpers.

Figure B-7. Location of Configurable Jumpers on Interface Board

Table B-3 lists the configuration options using either jumpers or 0  surface-mount resistors.

Table B-3. Interface Board Jumper Configurations

Header Description Pins Connected

Factory

Default

JP1 Dynamic C Setup

1–2

SMODE pins pulled up

(Programming Mode)

* The

MiniCore

will operate in Run Mode when these pins are not jumpered.

3–4 Reserved for future use

5–6 LED DS1 connected

7–8 Switch S1 connected

JP2

mini USB Connector Power

Supply Current Limiting

1–2 Nominal 700 mA

n.c. Nominal 500 mA