User`s manual

OEM User’s Manual 91
B.5 Interface Board Jumper Configurations
Figure B-7 shows the header locations used to configure the various Interface Board
options via jumpers.
Figure B-7. Location of Configurable Jumpers on Interface Board
Table B-2 lists the configuration options using either jumpers or 0  surface-mount resistors.
Table B-2. Interface Board Jumper Configurations
Header Description Pins Connected
Factory
Default
JP1 Dynamic C Setup
1–2
SMODE pins pulled up
(Programming Mode)
*
* The RCM5600W will operate in Run Mode when these pins are not jumpered.
×
3–4 Reserved for future use
5–6 LED DS1 connected
×
7–8 Switch S1 connected
×
JP2
mini USB Connector Power
Supply Current Limiting
1–2 Nominal 700 mA
×
n.c. Nominal 500 mA
JP1
JP2