User`s manual

90 MiniCore RCM5600W
B.4.1 Add Additional Boards
The Prototyping Board and the two accessory boards included with the Deluxe Develop-
ment Kit may be installed on the Interface Board as shown in Figure B-6.
Figure B-6. Install Additional Boards on Interface Board
1. Insert the header strip into header socket J2 on the Interface Board or the board already
installed above the Interface Board.
2. Line up the board being installed above the pins extending from the header socket and
the stand-offs/connectors.
3. Press down to install the board.
4. Insert additional plastic standoffs/connectors as shown to hold the board firmly in place
and to hold another board if desired.
When additional boards are installed, the board-to-board spacing is 0.7" (17.8 mm).
Multiple boards should be installed in this sequence from bottom to top.
• Interface Board with RCM5600W installed.
• Prototyping Board.
• Serial Communication accessory board.
• Digital I/O accessory board.
Install header connector strip
in bottom socket