User`s manual

OEM User’s Manual 65
The Digital I/O accessory board may also be used to run the BROWSELED.C, PINGLED.C,
and PINGLED_STATS.C sample programs. This accessory board is included only with the
Deluxe Development Kit.
To install the Digital I/O accessory board, insert the strip of header pins included with the
accessory board into the socket at J12 on the bottom side of the Digital I/O accessory
board. Then line up the Digital I/O accessory board with the Interface Board
standoffs/ connectors and install the Digital I/O accessory board pins into socket J2 on the
Interface Board. Secure the Digital I/O accessory board with the long plastic stand-
offs/connectors from above as shown in Figure 13—note that one plastic standoff/connec-
tor needs to be inserted “upside down” to secure the Digital I/O accessory board to the
antenna bracket.
Figure 13. Install Digital I/O Accessory Board
Pins 1–2, 3–4, 5–6, and 7–8 on headers JP5 and JP8 on the Digital I/O accessory board
must be jumpered. Pins 2–4 and 3–5 on header JP7 on the Digital I/O accessory board
must also be jumpered.
JP5
JP8
4
3
2
1
6
5
7
8
4
3
2
1
6
5
7
8
JP7
Install header connector strip
in bottom socket