User`s manual

OEM User’s Manual 37
4.4.1 Standalone Operation of the RCM5600W
The RCM5600W must be programmed via the Interface Board or via a similar arrange-
ment on a customer-supplied board. Once the RCM5600W has been programmed success-
fully, reset the RCM5600W. The RCM5600W may be reset by cycling power off/on or by
pressing the RESET button on the Interface Board. The jumper across pins 1–2 on header
JP1 on the Interface Board must be removed in order for the RCM5600W to operate in the
Run Mode after it is reset. The RCM5600W module may now be removed from the Inter-
face Board for end-use installation.
CAUTION: Power to the Interface Board or other boards should be disconnected when
removing or installing your RCM5600W module to protect against inadvertent shorts
across the pins or damage to the RCM5600W if the pins are not plugged in correctly.
Do not reapply power until you have verified that the RCM5600W module is plugged
in correctly.