User`s manual

20 MiniCore RCM5600W

3.2 Sample Programs

Of the many sample programs included with Dynamic C, several are specific to the

RCM5600W. These programs will be found in the SAMPLES\RCM5600W folder. Sample

programs in the SAMPLES folder one level up are generic samples that can be run on any

Rabbit-based product.

• FLASHLED.C—demonstrates the use of costatements to flash LED DS1 on the Inter-

face Board. PD0 on the RCM5600W is used to drive the LED.

• TOGGLESWITCH.C—monitors switch S1 and LED DS1 on the Interface Board. LED

DS1 on the Interface Board is turned on and off when you press switch S1. PD0 on the

RCM5600W is used to drive the LED, and PD1 detects the activity on switch S1.

Before you compile and run the fol-

lowing sample programs, make sure

that pins 1–2, 5–6, and 7–8 on

header JP1 of the Interface Board

are jumpered. The pins on header

JP2 must also be jumpered. Each

sample program has comments that

describe the purpose and function of

the program. Follow the instructions

at the beginning of the sample

program.

CAUTION: Do not jumper pins

1–3 on header JP1 on the Inter-

face Board.

JP1

JP2