User`s manual

OEM User’s Manual 15
Your PC should recognize the new USB hardware, and the LEDs next to the USB connec-
tor on the Interface Board will flash — if you get an error message, you will have to install
USB drivers. Drivers for Windows XP are available in the Dynamic C Drivers\Rabbit
USB Programming Cable\WinXP_2K
folder — double-click DPInst.exe to install
the USB drivers. Drivers for other operating systems are available online at
www.ftdichip.com/Drivers/VCP.htm.
The green power LED on the Interface Board should light up when you connect the USB
cable. The RCM5600W and the Interface Board are now ready to be used.
NOTE: A RESET button is provided on the Interface Board to allow a hardware reset
without disconnecting power.
NOTE: Pins 1–2 on header JP1 on the Interface Board must be jumpered to download
and debug applications and sample programs with Dynamic C running. Pins 1–2 should
be left unjumpered to run an program already loaded in flash memory.
CAUTION: Do not jumper pins 1–3 on header JP1 on the Interface Board.
Alternate Power Supply Connections — Deluxe Development Kit
The deluxe Development Kit contains a separate AC adapter that may be used to supply
power to the Interface Board and the RCM5600W when the USB cable is not connected or
when more power is needed than the USB cable is able to supply. The AC adapter may
also be used to supply power when the USB cable is connected, in which case the power
supply through the USB cable will be disconnected automatically.
Figure 5. Alternate Power Supply Connections—Deluxe Development Kit