User`s manual

OEM User’s Manual 13

2.2.2 Step 2 — Install Module on Interface Board

Position the RCM5600W module with the edge connectors facing the mini PCI Express

socket J1A at an angle as shown in Figure 3 below. Insert the edge connectors into the

mini PCI Express socket J1A, then press down on the opposite edge of the RCM5600W

module to snap it into place in holder J1B.

Figure 3. Install the RCM5600W Module on the Interface Board

Should you need to remove the

RCM5600W module, use two

fingernails to hold back the spring

clip at J1B from the two

RCM5600W corners, lift up the

edge of the RCM5600W above

J1B, then pull the RCM5600W

away to remove the edge connec-

tors from the mini PCI Express

socket.

CAUTION: Remove power before attempting to insert or remove the RCM5600W

in the mini PCI Express socket.

Interface

Board

J1A

J1B

RCM5600W

J1A

J1B