User`s manual

12 MiniCore RCM5600W
2.2 Hardware Connections
There are four4 steps to connecting the Interface Board for use with Dynamic C and the
sample programs:
1. Insert standoffs/connectors on the Interface Board.
2. Install the RCM5600W module on the Interface Board.
3. Connect antenna.
4. Connect the USB cable between the Interface Board and the workstation PC.
2.2.1 Step 1 — Prepare the Interface Board for Development
Insert a short plastic standoff supplied from the Development Kit in one of the corner
holes from the bottom of the Interface Board, then secure it with a long plastic standoff
from above as shown in Figure 2. Repeat this step so that plastic standoffs/connectors are
in place at three positions and the antenna bracket is at the fourth position.
Figure 2. Insert Standoffs/Connectors
CAUTION: Provide ESD protection such as smocks and grounding straps on your
footwear.while assembling the RCM5600W module, installing it on another
board, and while making or removing any connections.
Remember to use ESD protection regardless of whether you are working with the
RCM5600W module on the Interface Board or in your own OEM application.