User`s manual

OEM User’s Manual 107
NOTE: Switches S5–S8, LEDs DS5–DS8, and the corresponding configuration headers
JP10–JP14 and circuits are not stuffed.
Figure D-6 shows the locations of the configurable jumpers.
Figure D-6. Location of Configurable Jumpers on Digital I/O Accessory Board
PA4 DS1
JP8
1–2
JP9
1
PA5 DS2 3–4 2
PA6 DS3 5–6 3
PA7 DS4 7–8 4
PB0
S5
†
JP10
1–2
JP11
1
PB1 S6 3–4 2
PB2 S7 5–6 3
PB3 S8 7–8 4
PA0 DS5
JP13
1–2
JP14
1
PA1 DS6 3–4 2
PA2 DS7 5–6 3
PA3 DS8 7–8 4
* Switches S1–S4 are pulled high or low via jumpers on header JP7.
† Switches S5–S8 are pulled high or low via jumpers on header JP12 (not stuffed).
Table D-2. Digital I/O Accessory Board Switch/LED Connection Options (cont’d)
Default RCM5600W
Signal
Switch/LED
Connected via Alternate Connection
Header Pins Header Pin
JP7
JP5
JP8
JP10
JP13
JP12
JP6
JP9 JP11
JP14