User`s manual

106 MiniCore RCM5600W
D.3.1 Configuration
The pushbutton switches may be configured active high (pulled down) or active low
(pulled up) via jumper settings on header JP7 for the four switches installed. Jumpers on
JP12 may be set up in a similar way after additional switches are installed at S5–S8.
Figure D-5. Pushbutton Switch Configuration
The four LED output indicators are set up as sinking outputs. Four additional LEDs may
be installed at DS5–DS8.
Jumpers on headers JP5 and JP8 connect the RCM5600W signals to the pushbutton
switches or LEDs. These jumpers may be removed and other RCM5600W signals may be
connected to the switch or LED positions above these headers via headers JP6 and JP9.
Table D-2 lists the connection options for the switches and LEDs.
Table D-2. Digital I/O Accessory Board Switch/LED Connection Options
Default RCM5600W
Signal
Switch/LED
Connected via Alternate Connection
Header Pins Header Pin
PB4
S1
*
JP5
1–2
JP6
1
PB5 S2 3–4 2
PB6 S3 5–6 3
PB7 S4 7–8 4
47 kW
+V
JP7
S1S4
ACTIVE LOW
47 kW
+V
JP7
S1S4
ACTIVE HIGH