User`s manual

98 MiniCore RCM5600W
C.3 Using the Prototyping Board
The Prototyping Board provides the user with RCM5600W connection points brought out
conveniently to labeled points below header J2. The pinouts for header socket J2 are shown
in Figure C-4.
Figure C-4. MiniCore Boards Pinout
There is a 1.7" × 2.7" through-hole prototyping space available on the Prototyping Board.
The holes in the prototyping area are spaced at 0.1" (2.5 mm). +3.3 V and GND traces run
along the left edge of the Prototyping Board for easy access. Small to medium circuits can
be prototyped using point- to-point wiring with 20 to 30 AWG wire between the prototyping
area, the +3.3 V and GND traces, and the surrounding area where surface-mount compo-
nents may be installed. Small holes are provided around the surface-mounted components
that may be installed around the prototyping area.
Note:
These pinouts are as seen on
the Top Side.
+3.3 V
PE0
PE2
PE5
PE7
PD0
PD2
/RESET_IN
+3.3 V
PC0
PC2
PC4/TxB
PC6/TxA
PB0/SCLKB
PB2
PB4
PB6
+3.3 V
PA0
PA2
PA4
PA6
/IORD
STATUS
+3.3 V
GND
PE1
PE3
PE6
SMODE
PD1
PD3
/RESET
GND
PC1
PC3
PC5/RxB
PC7/RxA
PB1/SCLKA
PB3
PB5
PB7
GND
PA1
PA3
PA5
PA7
/IOWR
VBAT_EXT
GND
J2