User guide

Resetting Digi One/PortServer TS 2/4 Configuration to Defaults
Chapter 20 Digi One/PortServer TS 2/4 Troubleshooting 92
Resetting Digi One/PortServer TS 2/4 Configuration to Defaults
Use this topic to reset the Digi One/PortServer TS 2/4 configuration to defaults.
Note: This procedure causes the Digi One/PortServer TS 2/4 to lose all configuration changes. If
you have a complex configuration, contact Digi before performing for information on saving
your configuration. See "Digi Contact Information" on page 97 for information.
Procedure
1. Use a pen, the point of a paper clip, or some other device to press the recessed button on the front
panel.
2. While holding down the button, power on the Digi One/PortServer TS 2/4.
3. When the 1-5-1 LED pattern is displayed, release the button.
The device boots up.
Verifying the Digi One/PortServer TS 2/4 IP Address
Use this procedure to check the IP address on the Digi One/PortServer TS 2/4.
1. Connect a terminal to a Digi One/PortServer TS 2/4 port.
2. If the port is still using the default configuration, configure the terminal to use the following settings
(Otherwise, configure the terminal to match the port configuration):
• VT-100 emulation
• 9600 baud
• 8-bit characters
• 1 stop bit
• No parity
3. Press Enter to get a logon prompt from the Digi One/PortServer TS 2/4.
4. Log on to the Digi One/PortServer TS 2/4.
5. Use the set config command to verify the Digi One/PortServer TS 2/4 IP address.