User guide

Configuring UDP Multicast
Chapter 9 Configuring Autoconnection 52
6. Fill in the requested information and choose Add destination at the bottom of the page.
See the Help section for additional information on the settings.
7. Scroll to the bottom of the page. Under Description, choose upddest1.
8. Enter the requested information and choose Submit.
You can change the Description as desired. The IP address is the destination device server’s address and the
UDP port uses a base socket number of 2100 for UDP. The first port would be port number 2101.
9. Repeat these steps until you have added the necessary destinations.
Procedure for Configuring Inbound Socket Communication
1. Access the web interface by entering the Digi One/PortServer TS IP address in a browser’s URL window.
2. Log in to the Digi One/PortServer TS as root. The default password is dbps.
3. From the main menu, choose Configure > Port.
4. From the Port configuration screen, set the Device type to Printer, adjust other serial port communication
parameters as required by the connected device, and then choose Submit.