User guide

Modem Emulation AT Command Set
Chapter 8 Modem Emulation 44
S14
General Bit Mapped Options Status
Indicates the status of command options.
Default: 138 (8Ah) (10001010b)
Bit 0 This bit is ignored.
Bit 1 Command echo (En)
0 = Disabled (E0)
1 = Enabled (E1) (Default.)
Bit 2 Quiet mode (Qn)
0 = Send result codes (Q0) (Default.)
1 = Do not send result codes (Q1)
Bit 3 Result codes (Vn)
0 = Numeric (V0)
1 = Verbose (V1) (Default.)
Bit 4 Reserved
Bit 5 Tone (T)/Pulse (P)
0 = Tone (T) (Default.)
1 = Pulse (P)
Bit 6 Reserved
Bit 7 Originate/Answer
0 = Answer
1 = Originate (Default.)
*138 (8Ah)
S15 Reserved - - -
S16 Accepted but ignored. -- 0
S17 Reserved - - -
S18 Accepted but ignored. 0-255 s * 0
S19 Accepted but ignored. -- 0
S20 Accepted but ignored. 0-255 - * 0
S21
General Bit Mapped Options Status
Indicates the status of command options.
Default:52 (34h) (00110100b)
Bit 0 Set by &Jn command but ignored otherwise.
0 = &J0 (Default.)
1 = &J1
Bit 1 Reserved
Bit 2 CTS behavior (&Rn)
0 = CTS tracks RTS (&R0)
1 = CTS always on (&R1) (Default.)
Bits 3-4 DTR behavior (&Dn)
0 = &D0 selected
1 = &D1 selected
2 = &D2 selected (Default.)
3 = &D3 selected
Bit 5 RLSD (DCD) behavior (&Cn)
0 = &C0 selected
1 = &C1 selected (Default.)
Bit 6 DSR behavior (&Sn)
0 = &S0 selected (Default.)
1 = &S1 selected
Bit 7 Long space disconnect (Yn)
0 = Y0 (Default.)
1 = Y1
--*52 (34h)
S22 Accepted but ignored. - - * 117 (75h)
Register Function Range Units Saved Default