Technical data

PortServer Terminal Server Page 45
TFTP Error Messages
The host with the bootfile may pass back a TFTP error message, which the PortServer will
display in the alphanumeric display. This message will be in the form En,wheren can be one
of the following:
0 Error not defined, see error message (if any)
1 File not found
2 Access Violation
3 Disk Full or allocation exceeded
4 Illegal TFTP operation
5 Unknown transfer ID
6 File already exists
7 No such user
If the remote still will not work, push both arrow buttons (
4and 5 ) to boot from the
ROM, and check that the boothost ip address is correct, and that the bootfile path and name
are correct. Also ensure that your system supports TFTP.
To return to automatically booting from ROM, enter:
set config boothost=255.255.255.255
flow
Syntax: set flow option=value
The set flow commands set or display the hardware and software flow control parameters for
RS-232 serial ports. set flow range is used to specify multiple ports, or one specific port.
Options are:
aixon altpin cts dcd dsr dtr itoss
ixany ixoff ixon range ri rts save
Each of the above will have their own options, as outlined in the following descriptions. (More
than one option can be included in a command.)