Technical data
PortServer Terminal Server Page 43
config
Syntax: set config option=value
This sets or displays the network parameters configuration table entries. Options are:
domain gateway myname ip nameserv
netcx submask ether boothost bootfile
More than one configuration option can be included in a command.
The set config command writes to EEPROM, and informs you of the number of
locations found bad and corrected in EEPROM memory. A non-zero number is
worrisome only when the number of errors begins to approach 64, the maximum
number of entries in the EEPROM patch table. Anyone with more than 40 corrected
errors should contact Digi Technical Support for assistance.
“EP” appears on the front panel display any time a write to EEPROM is in progress.
domain=domain_name
Specifies the domain name.
gateway=ipaddress
Sets the IP address of the gateway.
myname=PortServer's_name
SetsthenodenameofthePortServerbox.
ip=ipaddress
Sets the PortServer's ip address.
nameserv=ipaddress
Specifies the name of the domain name server. If an address is not specified, the
host’s ip address must be entered using the set host covered on page 47.
realport=tcp_port_number
This is the RealPort TCP port number, which has a default value of 771 here and in
the RealPort drivers. If this number must be changed because of conflicts, remember
to change it both here and in the RealPort drivers.