Technical data

PortServer Terminal Server Page 11
Domain
Server’s
Name
If you have one, enter the IP address of the IP Name Service
machine that will translate names to addresses. This example
uses “192.83.159.2”:
#>set config nameserv=192.83.159.2
#>
Note that if you do not have an IP Name Service machine, you
can use the PortServer’s Set Host commands to build a table
of names and their IP addresses. (See page 47.)
Network
Subnet
Mask
Set your network subnet mask. (The PortServer’s default
setting is 255.255.255.0); that’s also the mask used in this
example:
#>set config submask=255.255.255.0
#>
Gateway
Address
If you have a gateway, set its IP address. (The default setting of
255.255.255.255 is used in this example):
#>set config gateway=255.255.255.255
#>
There are other PortServer parameters that can be configured. These are covered
individually in the Command Reference chapter.