User`s guide

Configure Physical Serial Ports
Chapter 5 Configure Ports 64
Apply All Ports Settings
As another aid in configuring serial ports, the Digi Passport unit supports
managing all ports simultaneously. This feature is referred to as
Apply all ports settings. If configuration changes are made to a port and
Apply all ports settings is enabled, the changes are automatically applied
to all ports. Ports can also be excluded from this Apply all ports settings
feature. When changing a parameter for all ports, all settings of the
complete page are applied to all ports.
Enable/disable the Apply all port settings feature for all ports
To enable or disable the Apply all ports settings feature for a port:
1. Enter the IP address of the Digi Passport unit in the address bar of a
web browser to access the web interface.
2. Under the Serial Port heading, click Configuration.
3. On the Ports configuration page, select All.
4. At the top of the Basic configuration page, for the Apply all ports in a
group setting, select Enable to enable the Apply all ports settings
feature for all ports, or Disable to disable it for all ports.
5. Click Save to flash and continue with other configurations, or click
Save & apply.
Enable/disable the Apply all port settings feature for individual ports
To enable or disable the Apply all ports settings feature for an individual
port:
1. Enter the IP address of the Digi Passport unit in the address bar of a
web browser to access the web interface.
2. Under the Serial Port heading, click Configuration.
3. On the Ports configuration page, select the port number.
4. On the Basic configuration page, click Advanced configuration.
5. On the Port management page, click Apply all ports settings.
6. On the Apply all ports settings page:
• To enable the Apply all ports settings for the port, select Enable.
• To disable the Apply all ports settings feature for the port, select
Disable to disable it for all ports.