User`s guide

Configure Physical Serial Ports
Chapter 5 Configure Ports 62
Quick-Start Procedure
Configure Ports with Automatic Device Recognition (Optional)
This procedure is the fastest way to configure Automatic Device
Recognition (ADR) for physical serial ports. It results in ports being
configured identically, starting from and retaining factory defaults for most
settings, and adjusting the most common parameters to fit the
requirements of typical installations. It also shows how to optionally
establish an automatic detection probe sequence to be performed on the
ports to detect the devices that are attached to the Digi Passport unit.
1. In the Web interface for the the Digi Passport unit, go to
Serial Port > Configuration. The Ports configuration page is
displayed.