User`s guide

Configure Access to Digi Passport via PPP
Chapter 2 Getting Started 34
Configure PPP from the Windows XP Interface
1. Select Start > Control Panel > Network Connections. The Network
Connections window is opened.
2. Select File > New connection to launch the New connection Wizard.
3. Select Connect to the network at my workplace and click Next.
4. Select Dial-up connection and click Next.
5. Enter Connection name and click Next.
6. Enter Phone number and click Next.
7. For Connection Availability, select Anyone or My use only and click
Next.
8. Click Finish.
9. Right-click the on the connection just created to open the connection
properties window.
10.On Security tab, check Advanced for Security options and click
Settings.
11. On the Advanced Security Settings window, set the parameters as
follows:
• Data encryption: Optional encryption (connect even if no
encryption)
• Allow these protocols: Unencrypted password(PAP)/Challenge
Handshake Authentication Protocol(CHAP).
Click OK.
12.Check the Run script checkbox, select Generic login, and click Edit.
13.Check the Show Terminal Window checkbox.
14.Run the dialup connection and click the Properties button.
15.Click the Security tab. In the Interactive logon and Scripting section,
check the Show Terminal Window checkbox.This option will display
the terminal window so that you can type a user name and password
manually.
16.In file switch.inf, edit following lines as instructed:
line 72: OK=<match>"login:" => OK=<match>"login :"
(insert a space character before ":")
line 80: COMMAND=<user name><cr> => COMMAND=admin<cr>
line 89: OK=<match>"password:" => OK=<match>"password :"
(insert a space character before ":")
line 97: COMMAND=<password><cr> => COMMAND=admin<cr>
Then save the switch.inf file.
17.On the Properties window, click OK.
18.On Dial-up connection, double-click the Connect icon.
19.Enter the User name and Password, then click the Dial button.