User`s guide

Configure Access to Digi Passport via PPP
Chapter 2 Getting Started 33
Configure Access to Digi Passport via PPP
The Digi Passport unit can be configured to support access to it via dial-in
Point-to-Point (PPP) connections. PPP can be configured from a variety of
interfaces, including the Digi Passport unit’s web interface, Windows XP, or
a Linux client.
Configure PPP from the Passport Web Interface
1. Select Network > PPP configuration >Basic PPP settings. Enter
settings:
• Dynamic IP address pool for incoming connections: select
Enable.
• First IP address: Enter the starting address of IP pool, for example,
192.168.161.200.
• Number of address: Enter the desired number for the address, for
example, 10. Must be greater than 1.
When all basic PPP settings are entered, click Save to flash.
2. Select Network > PPP configuration > incoming PPP connection.
Add a user for PPP connection and set parameters for each user:
For Authentication configuration, enter:
• Username: admin
• Password (new): admin
Specify the Password after setting all other parameters and just
before clicking Save to flash. If not, a Null Password can be speci-
fied while changing other parameters.
• Password (confirm): admin
• Authentication: CHAP/PAP
For Peer configuration, enter:
•(*) Automatically assign remote IP address from IP address pool.
•(v) Allow client access to local network via PPP connection.
Click Save to flash.
3. Go to Peripherals > Modem configuration. Enable the PPP
connection on the Modem.
4. Click Save & apply.