User`s guide

Certifications
Chapter 19 Specifications and Certifications 312
Certifications
Safety Certifications
• US: UL1950
• Canada: CSA 22.2 No. 60950
• Europe: EN60950 (CB Scheme Report)
Working Inside the Digi Passport Unit
NOTICE: Do not attempt to service the Digi Passport unit yourself, except
when following the instructions from Technical Support personnel. In such
a case, first perform the following actions:
• Turn off the Digi Passport unit.
• Ground yourself by touching an unpainted metal surface at the back of
the equipment before touching anything inside your equipment.
Safety Instructions
CAUTION: Do not operate the Digi Passport unit with the cover removed.
• To avoid shorting out the Digi Passport unit when disconnecting the
network cable, first unplug the cable from the equipment and then from
the network jack. When reconnecting a network cable to the equipment,
first plug the cable into the network jack and then into the equipment.
• To help prevent electric shock, plug the Digi Passport unit into a
properly grounded power source. The cable is equipped with 3-prong
plug to help ensure proper grounding. Do not use adapter plugs or
remove the grounding prong from the cable. If using an extension
cable, use a 3-wire cable with properly grounded plugs.
• To help protect the Digi Passport unit from transients in electrical power,
use a surge suppressor, line conditioner, or a continuous-protected (a
power supply that cannot be interrupted) power supply.
• Be sure that nothing rests on the Digi Passport unit cables and that the
cables are not located where they can be stepped on or tripped over.
• Do not spill food or liquids on the Digi Passport unit. If it gets wet,
contact Digi Technical Support.
• Do not push objects into the openings of the Digi Passport unit. Doing
so can cause fire or electric shock by shorting out interior components.
• Keep the Digi Passport unit away from heat sources and do not block
cooling vents.